Getting Started Manual
SMA 72" Cables - ChannelSync Clock
Usethe SMA 72" cable(s) provided to connect each SMA 10 GHz Clock
Output on the back of your MCM-Zi Master Control Module to the SMA 10
GHz Clock Input on each 10-xxZi Acquisition Module in your system.
NOTE
: Use an SMA torque wrench to ensure connections are properly tightened.
SMA 72" Male to Male Cable
On the back of the Master Control Module, connect one end of an SMA 72"
cable from a SMA 10 GHz Clock Output (labeled REF, unscrew the chain-
linked 50 Ω termination, if necessary) .
922561-00 Rev A
21