Table of Contents
Advertisement
Menu Bar
The top of the screen contains a menu bar of commonly used functions.
Whenever you touch one of these buttons and make a selection from its
drop-down menu, the dialog area at the bottom of the screen displays the
corresponding dialog.
Specific Menu Bar functions are referenced using arrow-separated path
descriptions. For example, the Save Setup function is referenced as File →
Save Setup....
NOTE
: For common oscilloscope operations, you don't need to use the top menu
bar (since you can access most dialogs from the Front Panel or from the Descriptor
Labels). However, it is the only way to access setup or other dialogs for Display
Setup, Save or Recall Waveform, Save or Recall Setups, Print Setup, Vertical
(Channel), Horizontal, or Trigger Status, Memory (Reference Waveform) Setup,
Pass/Fail Setup, or Utilities and Preferences Setup....
Quick Access Toolbar
The Quick Access toolbar is located on the right side of the menu bar. You
can use these toolbar buttons to quickly access Trigger, Processing and
Undo functionality.
Q
A
UICK
CCESS
Auto - Press to turn on Auto Trigger mode, which triggers the
oscilloscope after a time-out, even if the trigger conditions are not
met.
Normal - Press to turn on Normal Trigger mode, which triggers the
oscilloscope each time a signal is present that meets the conditions
set for the type of trigger selected.
Single - Press to turn on Single Trigger mode for the selected
channel, which arms the oscilloscope to trigger once (single-shot
acquisition) when the input signal meets the trigger conditions set for
the type of trigger selected. If the oscilloscope is already armed, it
forces a trigger.
922561-00 Rev A
T
F
RIGGER
UNCTIONS
Getting Started Manual
43
Advertisement
Table of Contents
