Cursor Setup - Teledyne LabMaster 10 Zi Series Getting Started Manual

Cursor Setup

After using one of the above methods to access cursors, the Cursors dialog
is displayed.
Cursor Types

Horizontal Abs - Provides a single, dashed, vertical line and cross-hair
marking for the specific cursor location. None of the Show controls
are provided; however, the Position 1 control is enabled on the right
of the dialog.

Horizontal Rel - Provides two, dashed, vertical lines and cross-hair
markings for the specific cursor locations. Since there are two cursors
involved, controls for Show along with Track, and Position 1 and 2
are available on the dialog.

Vertical Abs - Provides a single, dashed, horizontal line and cross-hair
marking for the specific cursor location. None of the Show controls
are provided; however, the Position 1 control is enabled on the right
of the dialog.

Vertical Abs - Provides a single, dashed, horizontal line and cross-hair
marking for the specific cursor location. None of the Show controls
are provided; however, the Position 1 control is enabled on the right
of the dialog.

Both Rel – Provides both Horizontal Rel and Vertical Rel cursor lines.
Show (for Relative Cursor Types)
Show controls (Absolute, Delta, Abs+Delta, and Slope) become available on
the dialog when Relative Cursors (Horizontal or Vertical Rel cursor types)
are chosen.
For Horizontal and Vertical Rel cursor types, you can also specify Position 1
and 2 time values for your cursor locations. You also have the option to
922561-00 Rev A
Getting Started Manual
105