Table of Contents
Advertisement
LabMaster 10 Zi Oscilloscopes
When the probe is not connected, there is only a C1 tab selection for
vertical channel setup and the user has the ability to select input coupling
and probe attenuation.
Channel dialog showing Input A's interface controls setup before connection.
After a probe is connected, it is recognized and an additional tab with the
probe model name is displayed to the right of the C1 tab. Click on the tab or
the probe field to display the probe dialog.
Channel dialog showing Input A's interface controls setup after connection.
This additional tab contains specific information on the connected probe.
Default values for the probes coupling and attenuation are automatically
downloaded from the probe, and these settings along with other attributes
are shown on the dialog.
The probe dialog showing the connected probe's control attributes.
36
922561-00 Rev A
Advertisement
Table of Contents
