Trigger Setup - Teledyne LabMaster 10 Zi Series Getting Started Manual

LabMaster 10 Zi Oscilloscopes
Vertical
Turn the L knob in the TRIGGER control group to adjust the trigger's
EVEL
vertical threshold.
Turn this knob to adjust the level of the trigger source or the highlighted
trace. Level defines the source voltage at which the trigger will generate an
event: a change in the input signal that satisfies the trigger conditions.
Alternatively, in the Trigger dialog, you can touch inside the Level control
and provide a value using your preferred input control method. Additional
information on using the touch screen controls can be found in the Dialog
Area. Quickly set a level of zero volts by touching the Zero Level button.
An arrow on the right side of the grid shows the threshold position. This
arrow is only visible if the trigger source is displayed.

Trigger Setup

Based on your Trigger Type selection, sections of the main Trigger dialog
and additional dialogs altogether vary.
Most trigger types have Type, Setup, and Level selections. The following
sections explain some of the standard setup configurations for different
trigger types.
1.
Make your Type selection by touching the button corresponding to
the desired trigger.
84
The time value is given in the title line of the Timebase
label at the lower-right of the grid.
922561-00 Rev A