Chapter 21 Troubleshooting And Faq; What Dialogs Use The Ios Cli Instead Of Snmp - Cisco 12000 User Manual

Administration

What Dialogs Use the IOS CLI Instead of SNMP?

Q.
A.
Table 21-2 Dialogs launched from Chassis objects
Dialog uses IOS CLI
(Need to set the Management
Passwords on the EM)
Configuration Editor
POS APS Status
RPR Configuration
RPR Status
BGP Address-Family Synchronization
BGP Address-Family Configuration
BGP Address-Family Status
OSPF Configuration
MPLS Forwarding Information
MPLS Trap Configuration Dialog
VRF Deployment
VRF Configuration
Table 21-3 Dialogs launched from Module objects
Dialog uses IOS CLI
(Need to set the Management
Passwords on the EM)
WRED-Rx Configuration
Cisco 12000/10700 v3.1.1 Router Manager User Guide
21-2
What dialogs are retrieving or configuring information using the IOS CLI instead of SNMP?
In Cisco 12000/10720 v3.1.1 Router Manager some dialogs use only the IOS CLI, some use only
SNMP, and some use both IOS CLI and SNMP.
instance.
When a dialog uses the IOS CLI, the IOS password must be set up. See
CLI Username and Passwords, page
Dialog uses SNMP
Chassis Configuration
Chassis Management Information
Chassis Inventory
Chassis Status
System Log
Command History
TCP Status
UDP Status
IP Routing Status
MPLS Interface Status
MPLS Tunnel Information
MPLS LDP Entity Status
MPLS LDP Peer Status
MPLS LDP Hello Adjacencies
VRF Status
VPN Status
Interface VRF Status
VRF Object Status
Dialog uses SNMP
Module Performance
Module Inventory
Module Status
Table 21-2, Table
4-5.
Dialog uses IOS CLI and SNMP
(Need to set the Management
Passwords on the EM)
SNMP Management
ATM Connection Upload
BGP Configuration
BGP Status
OSPF Status
Dialog uses IOS CLI and SNMP
(Need to set the Management
Passwords on the EM)
Chapter 21 Troubleshooting and FAQs
21-3, and Table 21-4 detail each
Entering or Changing IOS
OL-4455-01