Cisco 12000 User Manual page 496

Chapter 15 MPLS Management
Fault Management for MPLS Traffic Engineering
Figure 15-22 MPLS Tunnel Information Window—LSP Setup Tab
Select Tunnel
The Select Tunnel area displays the following information:
Tunnel Id—Displays the tunnel identification number.
Instance—Displays the tunnel instance of the LSP. It is useful to identify multiple instances of tunnels
for the purposes of backup and parallel tunnels.
Ingress LSR—Displays the source IP address of the LSP.
Egress LSR—Displays the egress LSR IP address.
Tunnel Info
Tunnel Descr—Displays a textual string containing information about the tunnel. If there is no
description this object contains a zero length string.
Tunnel Type—Displays whether or not the entry represents an interface.
Signalling Protocol—Displays the signaling protocol, if any, which was used to setup this tunnel.
Possible values are none, rsvp, crldp, or other.
Storage Type—This variable indicates the storage type for this object.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
15-40
OL-4455-01