Use Of Telecom Graphics Objects - Cisco 12000 User Manual

Chapter 2 Concepts
•
Table 2-3
Table 2-3
Logical Object
WRED:
CoS queue groups
ToFab Policies
CAR:
CAR policies
CAR access lists
Software: VRF Policies
Table 2-4
Table 2-4
Logical Object
PVC
SVC
Table 2-5
Table 2-5
Logical Object
Domain,
VLAN
VLAN sub-interfaces

Use of Telecom Graphics Objects

Cisco EMF uses Telecom Graphics Objects (TGO) in the Map Viewer application. TGO is a
TeleManagement Forum (TMF) sponsored initiative to provide standard graphical representations for
network topology maps.
A TGO displays additional information icons on top of the existing object icons displayed in Map
Viewer. The additional icons indicate a variety of information (for example, information on the state of
the object or event status information).
OL-4455-01
VLAN—Domain, VLAN, sub-interface objects. VLAN sub-interfaces can be configured on
Ethernet interfaces.
describes the management functions for Layer 3 QoS logical configurations.
Layer 3 QoS Logical Objects
Management Functions
Create, configure, apply, modify, delete and remove CosQ groups, WRED
ToFab and CAR objects.
Create, configure, apply(to an interface) and remove(from device and
interface) VRF Policies
describes the management functions for ATM logical objects.
ATM Logical Objects
Management Functions You Can Perform
Upload, sync, create, configure, manage, and delete/connect/disconnect on
main or sub-interfaces. Status information can be collected and displayed
for PVC objects only.
describes the management functions for VLAN objects.
VLAN Objects
Management Functions You Can Perform
Create and delete on Domain objects. Create, configure, manage, and delete
on VLAN and sub-interfaces.
Cisco 12000/10720 Router Manager Objects and Interfaces
Figure 2-2 provides an example of a TGO.
Cisco 12000/10700 v3.1.1 Router Manager User Guide
2-7