Editing An Existing Tofab Policy - Cisco 12000 User Manual

Chapter 11 Layer 3 QoS
Figure 11-14 ToFab Configuration Window—ToFab Policy Configuration Tab
Click Create.
Step 2
Step 3 Enter the WRED ToFab policy name, and then choose Ok. A window appears, confirming if you were
successful or not. The name of your new ToFab policy appears in the list box at the left side of the
window.
Modify the parameters as required. See
Step 4
Description" section for further details.

Editing an Existing ToFab policy

A ToFab Policy can be edited only if it is not associated to any line card. If the policy is associated to a
line card(s), it cannot be edited unless it is disassociated from the line card(s).
To edit an existing ToFab policy, proceed as follows:
Launch the Map Viewer, choose the Layer3QoSView. Right click on the WRED-MDRR object and
Step 1
choose Cisco 12000/10720 Manager>Configuration >ToFab>ToFab Configuration to launch the
WRED ToFab Configuration window. Refer
that allow you to launch the WRED ToFab Configuration window
Step 2 Choose the appropriate ToFab policy from the list displayed at the left side of the window.
OL-4455-01
"WRED ToFab Policy Configuration Window—Detailed
Table 11-1 on page 11-2
Cisco 12000/10700 v3.1.1 Router Manager User Guide
WRED ToFab Configuration
for information on different objects
11-33