Module Configuration Window-Detailed Description; Configuration Tab; Module Fault Management; Viewing The Module Fault Management Window - Cisco 12000 User Manual

Chapter 5 Managing Modules
Module Configuration Window—Detailed Description
The Module Configuration window displays a single Configuration tab.

Configuration Tab

The Configuration tab (see
Actions, and Commission Status.
Additional Descriptions
The Descriptions 1 and Descriptions 2 fields (optional) allow you to specify additional description
information for the selected module (if required).
Actions
The Actions area contains two buttons:
Commission—Commissions the selected module.
Decommission—Decommissions the selected module.
Commission Status
The Commission Status area displays the status of the last commission performed on the selected
module. Possible values are Succeeded or Failed.

Module Fault Management

The Module Fault Management window is a read-only window and provides fault information for a
selected module. You do not need to enter any information into any of the fields. This section provides
the following information:
•
•

Viewing the Module Fault Management Window

To view the Module Fault Management window, proceed as follows:
Step 1 Right click on a module and select the Cisco 12000/10720 Manager>Fault>Module Fault
Management option. See
the Module Fault Management window. The Module Fault Management window appears, with the Fault
Management tab displayed.
OL-4455-01
Figure 5-1 on page
Viewing the Module Fault Management Window
Module Fault Management Window—Detailed Description
Table 5-2 on page 5-2
5-4) displays three areas: Additional Descriptions
for information on which objects allow you to launch
Cisco 12000/10700 v3.1.1 Router Manager User Guide
Module Fault Management
5-7