Disassociating A Tofab Policy From A Line Card; Changing The Association Of A Tofab Policy - Cisco 12000 User Manual

Chapter 11 Layer 3 QoS
Choose the Chassis and Module to associate the ToFab policy from the list box displayed at the left of
Step 2
the window. More than one Chassis or Module can be selected at a time.
Choose the ToFab policy in the available ToFab policy list.
Step 3
Click Associate
Step 4

Disassociating a ToFab Policy from a Line card

To disassociate a ToFab policy from a line card, proceed as follows:
Launch the Map Viewer, choose the Layer3QoSView. Right click on the WRED-MDRR object and
Step 1
choose Cisco 12000/10720 Manager>Configuration>ToFab>WRED Rx Configuration to launch the
WRED Rx Configuration window. Refer
allow you to launch the WRED Rx Configuration window.
Step 2 Choose the Chassis and Module from the list boxes at the left of the window to which the ToFab policy
is associated.
Step 3 Click Disassociate

Changing the Association of a ToFab Policy

To change the association of a ToFab policy to a line card, proceed as follows:
Step 1 Launch the Map Viewer, choose the Layer3QoSView. Right click on the WRED-MDRR object and
choose Cisco 12000/10720 Manager>Configuration>ToFab>WRED Rx Configuration to launch the
WRED Rx Configuration window. Refer
allow you to launch the WRED Rx Configuration window.
Choose the Chassis and Module from the list boxes at the left of the window to which a ToFab policy
Step 2
is associated.
Choose the ToFab policy that you want to associate.
Step 3
Step 4 Click Associate
Note
OL-4455-01
If a ToFab policy was previously associated with the interface, it is removed and the new ToFab
policy is associated.
Table 11-1 on page 11-2 for information on which objects
Table 11-1 on page 11-2 for information on which objects
Cisco 12000/10700 v3.1.1 Router Manager User Guide
WRED Rx Configuration
11-37