Chapter 4
Managing Chassis
Starting Global Performance Logging
Global performance logging, when set, collects performance information on GRPs and interfaces on a
specified chassis. Performance data can then be viewed through performance menus or through the
Performance Manager.
Performance logging can also be started on a per module (GRP) or physical interface basis. For details
Note
on how to start performance logging for a selected module (GRP), see
on page
Ethernet, ATM, or DS-3), see
page
If you start global performance logging on a chassis, all subchassis objects are placed into the
performance logging on state. However, performance data is only collected for GRPs and interfaces, so
any other modules will not collect performance data, despite having a state of performance logging on.
Note
Global Performance Logging can use a lot of bandwidth, so use discretion.
To start global performance logging for a selected chassis, proceed as follows:
Open the Chassis Configuration window. See
Step 1
page 4-7
Select the relevant Chassis from the list displayed at the left of the window.
Step 2
Click Start to begin performance logging on the selected chassis. An Action Report window appears:
Step 3
Figure 4-4
OL-4455-01
5-9. For details on how to start performance logging for a selected physical interface (such as
"Starting Performance Logging for a Selected Interface" section on
10-5.
for further details.
Action Report Window
"Module Performance" section
"Viewing the Chassis Configuration Window" section on
Cisco 12000/10700 v3.1.1 Router Manager User Guide
Chassis Configuration
4-9