Epson S1D13504 Technical Manual page 278

Page 14
S1D13504
X19A-B-008-02
The Panel Tab select the following panel settings.
Panel Tab
Single/Dual
Disable Half-frame Buffer
Mono/Color
Format 2
STN/TFT
EL
Panel Interface
FPLINE Polarity
FPFRAME Polarity
Panel Dimensions
Non-Display Period
Frame Rate
Pixel Clock
HRTC/FPLINE
VRTC/FPFRAME
Predefined Panels
Selects between a single and dual panel. If no panel exists,
select single.
The half-frame buffer is used only for dual panels. Disabling the
half-frame buffer is not recommended as this will reduce the
display quality. Only available for dual panels.
Selects between a monochrome and color panel. If no panel
exists, select color.
Selects format 2 for 8-bit color passive LCD panels. For a
description of format 1 and format 2, see the S1D13504
Hardware Functional Specification , document number
X19A-A-002-xx.
Selects between a passive LCD and TFT panel.
Enable EL panel support.
Selects the LCD panel interface width in bits. The bit width
values are different for STN and TFT panels.
Selects the polarity of the FPLINE pulse.
Selects the polarity of the FPFRAME pulse.
Selects the width and height of the panel in pixels.
Selects the HNDP in pixels and the VNDP in lines.
Selects the desired frame rate in Hz.
Selects the desired pixel clock in MHz.
Selects the start position and pulse width in pixels. Only
available for TFT panels.
Selects the start position and pulse width in lines. Only available
for TFT panels.
Selects configuration values from a list of predefined panels
listed in the file panels.cfg
Epson Research and Development
Vancouver Design Center
13504DCFG Configuration Program
Issue Date: 01/02/01