Audio Configuration; Xconfiguration Audio Defaultvolume; Xconfiguration Audio Soundsandalerts Ringtone; Xconfiguration Audio Soundsandalerts Ringvolume - Cisco TelePresence SX20 Codec Reference Manual

Cisco TelePresence SX20 Codec

Introduction

Audio configuration

xConfiguration Audio DefaultVolume

Define the default volume for the speakers. The volume is set to this value when you switch on
or restart the video system. Use the Touch controller or remote control to change the volume
while the video system is running. You may also use API commands (xCommand Audio Volume)
to change the volume while the video system is running, and to reset to default value.
Requires user role: ADMIN, USER
Default value: 50
USAGE:
xConfiguration Audio DefaultVolume:
where
DefaultVolume
: Integer (0..100)
Select a value between 1 and 100. This corresponds to the dB range from -34.5 dB to
15 dB, in steps of 0.5 dB). If set to 0 the audio is switched off.

xConfiguration Audio SoundsAndAlerts RingTone

Define which ringtone to use for incoming calls.
Requires user role: ADMIN, USER
Default value: Sunrise
USAGE:
xConfiguration Audio SoundsAndAlerts RingTone:
where
RingTone
: Sunrise/Mischief/Ripples/Reflections/Vibes/Delight/Evolve/Playful/Ascent/
Calculation/Mellow/Ringer
Select a ringtone from the list.
SX20 Codec API Reference Guide CE8.1, APRIL 2016.
D15316.03
About the API xConfiguration xConfiguration
DefaultVolume
RingTone
xCommand

xConfiguration Audio SoundsAndAlerts RingVolume

Define the ring volume for incoming calls.
Requires user role: ADMIN, USER
Default value: 50
USAGE:
xConfiguration Audio SoundsAndAlerts RingVolume:
where
RingVolume
: Integer (0..100)
The value goes in steps of 5 from 0 to 100 (from -34.5 dB to 15 dB). Volume 0 = Off.

xConfiguration Audio Input Line [1] VideoAssociation MuteOnInactiveVideo

The audio source can be associated with a video source on the video input connector, and
you can determine whether to play or mute audio depending on whether the video source is
presented or not.
Requires user role: ADMIN
Default value: On
USAGE:
xConfiguration Audio Input Line
MuteOnInactiveVideo
where
n
: Unique ID that identifies the audio line input. Range: 1..1
MuteOnInactiveVideo
: Off/On
Off: The audio source is not associated with a video source. The audio will be played
locally and to far end regardless of whether the video source is presented.
On: The audio source is associated with a video source. The audio will be played (locally
and to far end) when the associated video source is presented. The audio will be muted
when the video source is not presented.
40
API Reference Guide
xStatus Appendices
RingVolume
n VideoAssociation MuteOnInactiveVideo:
Copyright © 2016 Cisco Systems, Inc. All rights reserved.