(3)
Release the harness out of 9 clamps, and
then disconnect each connector of CN8 and
CN20 on the SDL board.
(4)
Remove 4 screws, and then take off the sup-
port bracket.
(5)
Remove 4 screws, and then take off the front
bracket.
(6)
Remove 4 screws, and then take off the rear
bracket.
(7)
Remove 4 screws, and then take off the
switchback unit.
[C] Paper holding unit
(1)
Take off the front lower cover.
P.4-4 "[E] Front cover / Front upper cover
/ Front lower cover"
(2)
Remove 2 screws, and then take off the
paper holding unit.
Notes:
•
Do not lose the clutch shaft bushing.
•
When installing, engage the clutch shaft
bushing with the frame of the paper hold-
ing unit securely.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Clamp
SDL board
Fig. 4-79
Rear bracket
Front bracket
Fig. 4-80
Paper holding unit
Fig. 4-81
4 - 29
Support
bracket
Switchback unit
Bushing
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4