Units (Finisher Section) - Toshiba MJ-1104 Service Manual

4.2

Units (Finisher section)

[A] Junction box unit
(1) Take off the right upper cover.
 P.4-7 "[J] Right upper cover"
(2) Take off the relay guide, feeding discharge
brush and right cover.
 P.4-7 "[K] Relay guide / Feeding dis-
charge brush / Right cover"
(3) Remove 4 screws of the FIN board bracket.
(4) Release the harness out of 1 clamp, and
then disconnect each connector of CN6 and
CN8 on the IF board.
(5) Remove 2 screws of the IF board bracket.
Note:
When installing, screw the ground terminal
together with the bracket.
(6) Take off the 1 spring.
(7) Remove 1 screw, and then take off the sen-
sor bracet of the connection switch.
(8) Release the harness out of 2 clamps.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-35
clamp
IF board
Fig. 4-36
Sensor bracet
Fig. 4-37
4 - 13
FIN board
Clamp
Spring
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4