Toshiba MJ-1104 Service Manual page 87

(11) Loosen 1 screw, and then tighten the screw
by pushing the plate in the direction of the
arrow. (Loosen the belt tension.)
(12) Remove 5 screws, and then release the har-
ness out of the hole of the frame to take off
the buffer unit-1.
[D] Finishing tray unit
(1) Take off the grate-shaped guide.
 P.4-10 "[N] Grate-shaped guide"
(2) Take off the buffer unit.
 P.4-15 "[B] Buffer unit"
(3) Release the harness out of 2 clamps, and
then disconnect each connector of CN16 and
CN17 on the FIN board.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Plate
Fig. 4-53
Buffer unit-1
Fig. 4-54
Cramp
Fig. 4-55
4 - 19
Cramp
FIN board
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4