Toshiba MJ-1104 Service Manual page 121

(5) Disconnect the connector of the buffer roller
drive motor and release the harness out of
the clamp.
(6) Remove 5 screws, and then release the har-
ness out of the clamp and the hole of the
frame to take off the buffer unit-1.
(7) Remove 2 screws, and then take off the rear
side frame.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Buffer roller drive motor
Fig. 4-147
Fig. 4-148
Rear side
frame
Fig. 4-149
4 - 53
Clamp
Connector
Clamp
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4