(7)
Release the latch, and then take off the stack
exit belt home position sensor.
[J]
Stapler unit home position sensor (S10)
(1)
Open the front cover (MJ-1103) or the front
upper cover (MJ-1104).
(2)
Move the stapler to the position where the
stapler unit home position sensor is seen.
(3)
Release the latch, and then disconnect the
connector to take off the stapler unit home
position sensor.
[K] Stapler interference sensor (S11) / Actuator
(1)
Take off the stapler.
P.4-22 "[E] Stapler"
(2)
Release the latch, and then disconnect the
connector to take off the stapler interference
sensor.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Stapler unit home position sensor
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 98
Stack exit belt
home position sensor
Fig. 4-276
Fig. 4-277
Stapler interference sensor
Fig. 4-278