Toshiba MJ-1104 Service Manual page 174

[U] Stationary tray opening/closing switch (SW2)
(1) Take off the junction box unit.
 P.4-13 "[A] Junction box unit"
(2) Release the harness out of 4 clamps.
(3) Release the harness out of 3 clamps, and
then disconnect each connector of CN7 on
the FIN board.
(4) Remove 2 screws, and then take off the belt
tension arm, spring and belt.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Clamp
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 106
Clamp
Fig. 4-299
FIN board
Fig. 4-300
Spring
Belt tension arm
Belt
Fig. 4-301