Toshiba MJ-1104 Service Manual page 114

(11) Remove 1 clip and 10 E-rings. Then remove
6 paddles, 8 pins, 2 bushings. Then take off
the catching pad, catchi ng pad collar, spring,
gear and actuator.
Notes:
• Install the catching pad, catching pad col-
lar and spring in the directions shown in
the figure.
• When installing the paddle-1, paddle-2,
paddle-3, paddle-4, paddle-5 and paddle-
6, be sure that each star mark of the pad-
dles is seen as shown in the figure.
[D] Front transport roller / Rear transport roller
(1) Take off the stationary tray.
 P.4-1 "[A] Stationary tray"
(2) Take off the Junction box unit.
 P.4-13 "[A] Junction box unit"
(3) Close the buffer unit-1 halfway and leave it.
Then remove 1 screw.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Collar
Paddle
Bushing
Clip
Pin
Buffer unit-1
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 46
Spring Catching pad
Actuator
Bushing
Gear
Paddle
Fig. 4-126
Fig. 4-127
Screw
Fig. 4-128