Toshiba MJ-1104 Service Manual page 92

(3) Remove 2 screws, and then take off the sen-
sor rail.
Note:
When installing the movable tray drive unit,
fix it at the position where the gap between
the center mark of the scale on the sensor
rail and the edge of the movable tray posi-
tion-a sensor is from 0 to 1 mm. Be sure to
adjust the installation position by shifting the
movable tray shift frame and measure the
positions at the upper and lower measuring
points on the sensor rail as shown in the fig-
ure.
(4) Release the harness out of 3 clamps, and
then disconnect the connector of CN15 on
the FIN board.
(5) Disconnect the connector of the movable
tray shift motor.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Sensor rail
Sensor rail
Sensor
Measure
0mm to 1.0mm
Cramp
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 24
Fig. 4-66
Fig. 4-67
FIN board
Fig. 4-68