Toshiba MJ-1104 Service Manual page 136

(3) Remove 2 screws and then take off the
bracket.
(4) Disconnect the connector and remove the
belt. Then remove 2 screws to take off the
stack transport motor.
[I] Stapler unit shift motor (M9)
(1) Take off the rear cover.
 P.4-6 "[G] Rear cover"
(2) Disconnect all the connectors of the FIN
board and then release the harness from the
clamp.
(3) Remove 4 screws from the FIN board
bracket.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Bracket
Stack transport motor
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 68
Fig. 4-192
Belt
Fig. 4-193
Bracket
Fig. 4-194