Stapling/Folding Position Adjustment In Saddle Unit - Toshiba MJ-1104 Service Manual

5.3

Stapling/folding position adjustment in saddle unit

Perform this adjustment when the saddle control PC board was replaced or the stapling/folding position
must be changed for some reason.
Prepare 2 types of booklet samples using the main unit and use them for adjustment accordingly.
(1) Create 2 types of booklet samples (1 set each) using the main unit.
Media type
Paper size
Number of sheets
(2) Measure the stapling and folding positions of the samples, and then perform adjustment accord-
ingly.
For stapling and folding, paper on the stacker of the stacker unit is moved to an exclusive mech-
anism for stapling or folding. Therefore adjustment must be performed individually for the folding
stopping position of the stacker and the stapling stopping position.
* Check the folding position at the centerfold page of the sample.
* Check the stapling position at the centerfold page of the sample.
MJ-1103/1104
ADJUSTMENTS
Sample 1
Recomended paper
A4
5 sheets
Center
Paper exit
direction
page
-2mm - +2mm
Fig. 5-6
When the staples are bent
Staple
Do not include the
width of the staples
-0.5mm - +0.5mm
Folding line
Fig. 5-7
5 - 6
Sample 2
Recomended paper
A3
5 sheets
fold
-2mm - +2mm
Staple
-0.5mm - +0.5mm
Folding line
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved