Toshiba MJ-1104 Service Manual page 85

[C] Buffer unit-1
(1) Take off the rear cover.
 P.4-6 "[G] Rear cover"
(2) Take off the control panel unit.
 P.4-3 "[D] Control panel unit"
(3) Take off the stationary tray.
 P.4-1 "[A] Stationary tray"
(4) Release the harness out of 5 clamps, and
then disconnect each connector of CN3,
CN4, CN5, CN6, CN8 and CN10 on the FIN
board.
(5) Disconnect the relay connector.
(6) Disconnect the connector of the buffer tray
guide motor.
(7) Release the harness leading from other units
from 3 clamps.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Relay
connector
FIN board
Fig. 4-47
Connector
Buffer tray guide motor
Fig. 4-48
Clamp
Fig. 4-49
4 - 17
Clamp
Clamp
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4