Download Print this page

Paper Transport Jam In Saddle Stitch Section (Mj-1104); Paper Jam In Saddle Stitch Finisher Transport Section - Toshiba MJ-1104 Service Manual

Hide thumbs

Advertisement

6.2

Paper Transport Jam in Saddle Stitch Section (MJ-1104)

6.2.1

Paper jam in Saddle Stitch Finisher transport section

[EAA0]
Paper remaining in Saddle Stitch Finisher
Is there any paper remaining in the paper transport path in the equipment or the saddle stitch
section of the Finisher?
YES
Remove the paper.
NO
Is the paper too short for specifications?
YES
Use paper accepted in the specifications.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the junction box
paper detection sensor (S24)?
Is there a disconnection of the connector, incorrect installation or breakage of the transport path-
2 (S27)?
Is there a disconnection of the connector, incorrect installation or breakage of the transport path-
3 (S28)?
Is there a disconnection of the connector, incorrect installation or breakage of the ejecting roller
sensor (S29)?
l
YES
Reconnect the connector securely if there is any disconnection.
l
Reinstall the sensor correctly if there is any incorrect installation.
Replace the sensor if there is any breakage.
NO
Is the harness between the junction box paper detection sensor (S24) and the CN8 of the inter-
face PC board (I/F) disconnected or open circuited?
Is the harness between the transport path-2 sensor (S27), transport path-3 sensor (S28) or
ejecting roller sensor (S29) and the CN20 of the saddle control PC board (SDL) disconnected or
open circuited?
Is any of the harnesses between the CN1 or CN2 of the interface PC board (I/F) and the CN10
or CN13 of the saddle control PC board (SDL) disconnected or open circuited?
Is any of the harnesses between the CN5 or CN7 of the interface PC board (I/F) and the CN25
or CN27 of the finisher control PC board (FIN) disconnected or open circuited?
l
Reconnect the connector securely if there is any disconnection.
YES
Replace the harness if open circuited.
NO
1. Replace the saddle control PC board (SDL).
2. Replace the finisher control PC board (FIN).
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
6 - 15
MJ-1103/1104
TROUBLESHOOTING
6

Hide quick links:

Advertisement

loading

  Related Manuals for Toshiba MJ-1104

This manual is also suitable for:

Mj-1103