Toshiba MJ-1104 Service Manual page 76

(3) Release the harness from 1 clamp.
Note:
When installing the right cover, pull the har-
ness from the board access cover side tightly
and fix it with a clamp in order not to permit
the harness to slack off.
(4) Remove 4 screws, and then take off the right
cover by sliding it upward.
(5) Disconnect the relay connector from the con-
nection sensor. Then take off the right cover.
Note:
When installing the right cover, hang the 2
hooks of the cover on the holes of the frame.
[L] Left upper cover
(1) Remove 3 screws, and then take off the left
upper cover.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Clamp
Left upper cover
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 8
Fig. 4-21
Hook
Hook
Right cover
Fig. 4-22
Fig. 4-23