Units (Saddle section: MJ-1104)
[A] Saddle unit
Take off the front lower cover.
P.4-4 "[E] Front cover / Front upper cover
/ Front lower cover"
Remove 3 screws, and then take off the SDL
Release the harness out of 3 clamps, and
then disconnect each connector of CN10 and
CN13 on the SDL board.
Place a table beneath the pulled-out saddle
unit to steady it.
Store (flip up) the saddle unit support before
placing a table beneath the unit.
Remove 8 screws and store the right and left
DISASSEMBLY AND INSTALLATION
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 26
SDL board cover