Adjustments; Adjusting The Alignment Position - Toshiba MJ-1104 Service Manual

5.

ADJUSTMENTS

Note:
Before performing each adjustment, make sure that all covers (incl. those of the finisher and host
machine) are closed. Otherwise, the power is not supplied to the finisher and the adjustment may
not be performed properly.
5.1

Adjusting the Alignment Position

Perform this adjustment after replacing the Finisher control board or when the alignment position must
be changed for some reason.
Adjustment must be performed with 2 types of adjustment sheets for the A4 and LT series.
The adjustment value of A4 will be applied to the operation with A3, A4, A4-R, B4, B5, FOLIO, 8K, 16K.
The adjustment value of LT will be applied to the operation with LD, LG, LT, LT-R, COMP, 13 LG, 8.5"
SQ.
(1) Turn OFF the power of the equipment.
(2) Remove 2 screw and take off the board access cover.
(3) Set the SW1 on the Finisher control board as shown in the figures below.
Adjusting for A4 size paper:
Turn ON pin 2 and 4.
Adjusting for LT size paper:
Turn ON pin 1, 2, and 4.
Adjusting for A4 size paper
4 3
Adjusting for LT size paper
4 3
(4) Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
The alignment plate moves to the A4 or LT size position and stops.
(It stops at the position of -5 steps from the center value of the adjustment range.)
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
2 1
ON
2 1
ON
Fig. 5-1
5 - 1
Board access cover
MJ-1103/1104
ADJUSTMENTS
5