Disassembly And Installation; Covers - Toshiba MJ-1104 Service Manual

4.

DISASSEMBLY AND INSTALLATION

4.1

Covers

[A] Stationary tray
(1) Open the stationary tray.
(2) Loosen 2 screws each from the front and
back side tray, and remove 2 right side
screws.
(3) Lift the stationary tray upward to take off
while pulling the jam access lever.
Notes:
• Be sure to install or remove the stationary
tray with the stationary tray being opened,
otherwise the upper exit roller guide may
be damaged.
• Be sure not to damage the actuator of the
stationary tray paper-full sensor.
Notes:
• Be sure not to lose 4 pins of the buffer
unit-1.
• Before installing the stationary tray, adjust
the installing positions of the 4 pins of the
buffer unit-1 to the center position.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Actuator
Stationary
tray
Fig. 4-1
Pin
Fig. 4-2
4 - 1
Jam access lever
Buffer unit-1
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4