4.11 PC Boards / Discharge Brush
[A] Finisher control PC board (FIN board)
Note:
After the Finisher control PC board (FIN board) has been replaced, check that the firmware is the
latest version. If not, upgrade it.
P.7-6 "7.2.1 Update of CNV board"
(1)
Take off the rear cover.
P.4-6 "[G] Rear cover"
(2)
Disconnect all connectors connecting to the
FIN board.
(3)
Remove 4 screws, and then take off the FIN
board.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
FIN board
FIN board
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 120
Fig. 4-340
Fig. 4-341