Toshiba MJ-1104 Service Manual page 181

[E] Stacker paper detection sensor (S30)
(1) Take off the switchback unit.
 P.4-28 "[B] Switchback unit"
(2) Take off the paper holding unit.
 P.4-29 "[C] Paper holding unit"
(3) Remove 2 screws of the stacker guide.
Note:
Be careful not to damage the harness fixed
on the back side of the stacker guide with a
clamp.
(4) Release the harness out of 3 clamps.
(5) Remove 2 screws, and take off the sensor
bracket.
(6) Release the latch, and then take off the
stacker paper detection sensor.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-320
Sensor bracket
Fig. 4-321
Fig. 4-322
4 - 113
Stacker guide
Clamp
Stacker paper
detection sensor
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4