Folding Position Adjustment - Toshiba MJ-1104 Service Manual

5.3.1

Folding position adjustment

(1) Turn OFF the power of the equipment.
(2) Remove 2 screw and take off the board access cover.
(3) Set the SW1 on the Finisher control board as shown in the figures below.
Turn ON pin 1 and 4.
4 3
(4) Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
(5) Press [Button 1] on the touch panel 10 times and then press [Button 2] once. Then press [Button
1] again 2 times, and [Button 2] once again. (Adjustment of LD and A3 paper starts.)
MJ-1103/1104
ADJUSTMENTS
2 1
ON
Fig. 5-12
LED3 LED2
Button1
Fig. 5-13
Board access cover
LED1
Button2
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
5 - 8