Toshiba MJ-1104 Service Manual page 153

(8) Remove 2 screws, and then disconnect the
relay connector and remove the arm to take
off the bracket.
Note:
When installing the gate solenoid, adjust the
edge of the bracket to come at the mark on
the scale one step left from the center as
shown in the figure and fix it with 2 screws.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-240
Scale
Fig. 4-241
4 - 85
Bracket
Relay connector
Bracket
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4