Toshiba MJ-1104 Service Manual page 96

Notes:
When the saddle unit was installed, take off
the saddle cover to check if the joint section
of the pivot on the Finisher side and the plate
on the saddle unit side is smooth.
1. Take off the saddle tray.
 P.4-2 "[C] Saddle tray"
2. Open and close the saddle unit to check if
the joint section of the pivot on the Fin-
isher side and the plate on the saddle unit
side is smooth, and also if the plate on the
Finisher side contacts with the plate on
the saddle unit side at 4 positions.
3. If not, loosen 2 screws of the Finisher
side bracket and 1 screw on the saddle
unit side to determine the proper posi-
tions while the saddle unit is left closed.
[B] Switchback unit
(1) Take off the saddle unit.
 P.4-26 "[A] Saddle unit"
(2) Remove 4 screws, and then take off the
upper safety cover.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Proper position
Finisher
side plate
Adjustment required
Finisher
side plate
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 28
4 sections of the
plate are contacted
Saddle unit
side plate
Any of 4 sections
is not contacted
Saddle unit
side plate
Fig. 4-76
Pivot
Finisher
Saddle unit
side plate
side plate
Fig. 4-77
Upper safty cover
Fig. 4-78