Table of Contents
Advertisement
5.2
Adjusting the Stapling Position
Perform this adjustment after replacing the Finisher control board or when the stapling position must be
changed for some reason.
(1)
Turn OFF the power of the equipment.
(2)
Remove 4 screw and take off the board access cover.
(3)
Set the SW1 on the Finisher control board as shown in the figures below.
When adjusting the rear side for A4 size paper:
Turn ON pin 1, 3, and 4.
When adjusting the front side for A4 size paper:
Turn ON pin 3 and 4.
When adjusting the rear side for LT size paper:
Turn ON pin 1, 2, 3, and 4.
When adjusting the front side for LT size paper:
Turn ON pin 2, 3, and 4.
When adjusting the rear side
for A4 size paper
4
3
2
1
ON
When adjusting the front side
for A4 size paper
4
3
2
1
ON
(4)
Turn ON the power of the equipment while [0] button and [8] button are pressed simultaneously.
The alignment plate moves to the rear or front side stapling position and stops. (It stops at the
position of -20 steps from the center value of the adjustment range.)
MJ-1103/1104
ADJUSTMENTS
When adjusting the rear side
for LT size paper
4
3
2
1
ON
When adjusting the front side
for LT size paper
4
3
2
1
ON
Fig. 5-4
5 - 4
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Board access cover
Hide quick links:
Advertisement
Table of Contents
