Toshiba MJ-1104 Service Manual page 175

(5) Remove 4 screws, and then take off the
switch bracket.
(6) Remove 2 screws, and then take off the sta-
tionary tray opening/closing switch.
[V] Stapler interference switch (SW3)
(1) Take off the rear cover.
 P.4-6 "[G] Rear cover"
(2) Take off the grate-shaped guide.
 P.4-10 "[N] Grate-shaped guide"
(3) Release the harness out of 3 clamps, and
then disconnect the connector of CN19 on
the FIN board.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-302
Stationary tray
opening/closing switch
Fig. 4-303
Clamp
Fig. 4-304
4 - 107
Switch
bracket
FIN board
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4