Toshiba MJ-1104 Service Manual page 90

(8) Move the stapler to the staple replacing posi-
tion (the first position from the front).
(9) Remove 4 screws and take off the stack
transport roller-2 in the finishing tray unit
from the frame. Move the stack transport
roller-1 as shown in the figure, and then lift
the front side of the finishing tray unit to take
it off.
Note:
Be sure not to deform the finishing tray
guide.
[E] Stapler
(1) Open the front cover (MJ-1103) or the front
upper cover (MJ-1104).
(2) Move the stapler to the staple replacing posi-
tion (the first position from the front).
(3) Release the clamp to disconnect the flexible
cable out of the connector.
Note:
When installing the stapler, place the flexible
cable on the protrusion of the stapler and fix
it with the clamp.
(4) Remove 1 screw, and then take off the staple
carrier.
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
Finishing tray unit
Stack transport
roller-1
Flexible cable
Clamp
protrusion
protrusion
Staple carrier
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 22
Finishing tray guide
Fig. 4-61
Fig. 4-62
Fig. 4-63