Table of Contents
Advertisement
(4)
Release the harness out of 1 clamp, and
then disconnect each connector of CN6 and
CN8 on the IF board.
(5)
Remove 2 screws of the IF board bracket.
Note:
When installing, screw the ground terminal
together with the bracket.
(6)
Take off the 1 spring.
(7)
Remove 1 screw, and then take off the sen-
sor bracet of the connection switch.
(8)
Release the harness out of 2 clamps.
(9)
Remove 2 screws, and then take off the con-
nection switch.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
clamp
IF board
Fig. 4-308
Sensor bracket
Fig. 4-309
Fig. 4-310
4 - 109
Clamp
Spring
Connection switch
MJ-1103/1104
DISASSEMBLY AND INSTALLATION
4
Hide quick links:
Advertisement
Table of Contents
