Pump/Asf Motor And Solenoid Removal; Asf Unit Removal - Epson Stylus Color 980 Service Manual

EPSON Stylus Color 980

4.2.7.4 Pump/ASF Motor and Solenoid Removal

1. Remove the printer mechanism. (See Section 4.2.2.)
2. When removing the solenoid, remove one screw securing the
solenoid to the DE subassembly frame, and remove the solenoid.
To remove the pump/ASF motor, remove three screws securing the
DE subassembly frame to the back of the printer mechanism, then
remove the DE subassembly frame along with the pump/ASF motor.
3. Remove two screws securing the pump/ASF motor to the DE
subassembly frame, and remove the pump/ASF motor.
Screws securing the DE Subassembly Frame
to the Printer Mechanism
DE Subassembly Frame
Screws securing the Pump/ASF Motor
Figure 4-22. Pump/ASF Motor and Solenoid Removal
Disassembly and Assembly

4.2.7.5 ASF Unit Removal

1. Remove the DE subassembly frame. (See Section 4.2.7.4.)
2. Remove the E-ring fixing the ASF drive shaft and remove the ASF drive gear.
3. Remove three screws securing the ASF unit.
4. Holding the paper hold lever up to the left, remove the ASF unit.
Screw securing
the Solenoid
Disassembly Procedures
Figure 4-23. ASF Removal
When install the ASF be sure to use the correct type of
the screws, as shown below:
Screw with a flat head: on the right toward the front
side of the printer.
Screw with a washer: on the left toward the front
side of the printer.
Screw with a round head: on the left toward the
front side of the printer, screwed horizontally.
Revision A
115