Removing The Deck Lifter Motor (M102) - Canon NP6260 Service Manual

CHAPTER 8 PAPER DECK-A1
4. Removing the Deck Lifter Motor
(M102)
1) Open the compartment of the deck;
remove all copy paper, if any.
2) Turn on the copier; if the lifter of the
deck is up, push the sensor lever
of the paper supply position inside
the compartment with a finger. Stop
the lifter about 7 cm from the
base of the compartment, and insert
a hex wrench
lifter drive shaft
drive shaft temporarily in place to
prevent it from turning.
8-34
COPYRIGHT © 1997 CANON INC.
into the hole of the
, and fix the lifter
CANON NP6560/NP6360/NP6260 REV. 0 NOV. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 8-403
Figure 8-404