Scan To Home; Using Scan To Home - Xerox ColorQube 9201 User Manual

Scan to Home

Scan to Home

Scan to Home allows you to scan hard copy originals at the ColorQube™ 9201/9202/9203 and send
them to a destination on the network which is specified as your "Home" destination.
You enter your Network Authentication
log in at the device. The device displays
one Scan to Home template. When you
scan a document the authentication
server provides the information as to who
is logged in at the device.
The Workflow Scanning option needs to
be installed before this feature can be
used but it is NOT necessary for the
Workflow Scanning repositories and
templates to be configured.
Your System Administrator enables the Scan to Home option in Internet Services. Your System
Administrator also needs to enable Network Authentication for this feature to be available.
Lightweight Directory Application Protocol (LDAP) connectivity may also be used.

Using Scan to Home

The Scan to Home option must be enabled and setup by the System Administrator in order for the Scan
to Home template to be available on the device. You must also be logged in on the device using
Network Authentication to use this option.
1. Load the original documents in the document feeder or on the document glass.
2. Press the Clear All (AC) button twice and then Confirm to cancel any previous screen programing
selections.
3. To log in select the Log In/Out button
on the control panel.
174 ColorQube™ 9201/9202/9203
Workflow Scanning