Stapling Options - Xerox ColorQube 9201 User Manual

Stapling Options

The stapling options available are dependent on the finishing device available and the configuration
setup. For information about the available finishing devices, refer to
• 1 Staple when this option is selected,
a single staple is positioned in the top
left corner of the output.
• 2 Staple when this option is selected,
two staples are positioned parallel to
the left or top edge of the copies.
• Multi-Staple when this option is
selected, depending on the size of
your copy paper, either three or four
staples will be positioned parallel to
the left edge or your copies. For
example:
• 4 Staples = A4 LEF, A3, 8.5x11" LEF, 11x17", 8x10" LEF.
• 3 Staples = 8x10" SEF, 8.5x11" SEF, 8.5x5.5" LEF, A4 SEF, A5 LEF, 8.5x14" SEF, B5 SEF.
Note: SEF is Short Edge Feed and LEF is Long Edge Feed.
• Use the Original Orientation option to select the orientation of the originals being scanned. Select
Portrait or Landscape.
• Use the Paper Supply option to select the output media required.
To achieve some of the staple options, the copy paper will need to be loaded in a specific orientation -
either Long Edge Feed (LEF) or Short Edge Feed (SEF) as shown in this table.
Paper Size and
Orientation
A4, 8.5x11" LEF
A4, 8.5x11" SEF
A4, 8.5x11" SEF
Note: For some selections the device will rotate the image. If you are unable to staple, ensure that
Image Rotation is On in Tools. Refer to the
information.
Output Required
LEF A4, 8.5x11"
Single Staple
Top Left
SEF A4, 8.5x11"
Single Staple
Top Left
SEF A4, 8.5x11"
Single Staple
Bottom Left
Administration and Accounting
Finishing Devices
Original Orientation
ColorQube™ 9201/9202/9203
Copy Options
on page 23.
Output Tray
Orientation
guide for more
21
Copy