Advertisement
Provision the Octal-Port x TU-C Line Cards
To convert each slot provisioned for 4xflexi DMT to 8xDMT use the following procedure.
Record and back up the DSL profiles assigned to each port. Each port will be set to the default
Step 1
8xDMT profile after provisioning the slot for the new line card.
Type the following CLI command:
Step 2
DSLAM#show running-config
Remove the flexi DMT line card from the desired slot.
Step 3
Type the following CLI command:
Step 4
DSLAM# configure terminal
To remove flexi DMT provisioning from slot 1, type the following CLI command:
Step 5
DSLAM(config)#no slot 1
Type the following CLI command:
Step 6
DSLAM(config)#interface atm 1/1
Type the following CLI command:
Step 7
DSLAM(config-if)#dsl profile profile-name (where profile-name is name recorded previously)
Repeat Steps 4 through 7 for ports 2 through 4.
Step 8
Step 9
For each of the 4 new ports (ports 5 through 8), type the following CLI commands:
a.
interface atm 1/5
b.
dsl profile profile-name (where profile-name is the desired profile for the new port)
Install the new 8xDMT line card.
Step 10
Verify CPE Compatibility
Check with a Cisco customer representative to verify CPE compatibility with the 8xDMT.
Port Mapping of Subscriber Connectors to Slots and Ports
The subscriber connectors are numbered 1 to 10.
to card slots and ports. In the table, an asterisk (*) indicates a port that is not available on quad-port
xTU-C line cards.
OL-0991-01
Type the following CLI command:
Type the following CLI command:
Cisco 6260 Quad-Port Flexi ATU-C to Octal-Port DMT ATU-C Line Card Conversion Procedures
Port Mapping of Subscriber Connectors to Slots and Ports
Table 5
shows how subscriber connectors correspond
15
Advertisement
