Displaying The Port Mac Address - Cisco WS-C2950SX-48-SI Configuration Manual

Displaying the Port MAC Address

Port
----- -------- ----------------- -------- ----------------- ------------------
2/1
Port
----- ---------- -------------------- ----- -----
2/1
Port
----- ---------- ---------- ---------- ---------- ---------
2/1
Port
----- ---------- ---------- ---------- ---------- --------- --------- ---------
2/1
Last-Time-Cleared
--------------------------
Mon Jun 11 2001, 07:26:48
Console> (enable)
Displaying the Port MAC Address
In addition to displaying the MAC address range for a module using the show module command, you
can display the MAC address of a specific port in the switch using the show port mac-address
command.
To display the MAC address for a specific port, perform this task in privileged mode:
Task
Display the MAC address for a specific port.
This example shows you how to display the MAC address of a specific port:
Console> show port mac-address 4/1
Port
----- ----------------------
4/1
This example shows you how to display the MAC addresses of all ports on a module:
Console> show port mac-address 4
Port
----- ----------------------
4/1
4/2
4/3
4/4
.
.
.
4/47 00-50-54-bf-59-92
4/48 00-50-54-bf-59-93
Catalyst 4500 Series, Catalyst 2948G, Catalyst 2980G Switches Software Configuration Guide
20-4
Num-Addr Secure-Src-Addr
0
Status Channel
Mode
inactive auto silent
Align-Err FCS-Err Xmit-Err
- 0
Single-Col Multi-Coll Late-Coll
0 0
Mac address
00-50-54-bf-59-64
Mac address
00-50-54-bf-59-64
00-50-54-bf-59-65
00-50-54-bf-59-66
00-50-54-bf-59-67
Age-Left Last-Src-Addr
- -
Admin Ch
Group Id
1 0
Rcv-Err UnderSize
998 1012
Excess-Col Carri-Sen Runts
0 0
Command
show port mac-address [mod[/port]]
Chapter 20 Checking Status and Connectivity
Shutdown/Time-Left
- - -
0
Giants
0 1012
—
Release 8.1
0
78-15486-01