MERLIN LEGEND Communications System Release 6.1
System Manager's Guide 555-661-118
6
Managing the System
Removing a CTI Link
Follow the procedure in the preceding topic, "Busying-Out and Restoring
the MLX Module," to restore service on the module where the CTI link is
located.
When you have finished, file Form 2a with the rest of the planning forms.
To install the server-related hardware associated with the link, contact your
Lucent Technologies representative.
Programming Instructions
Console Procedure
PC Procedure
Removing a CTI Link
Use this procedure to remove the programming for a CTI (Computer Telephony
Integration) link from an MLX port on a 008 or 408 MLX module. This
hardware/software feature is available in Release 5.0 and later systems operating
in Hybrid/PBX mode.
NOTE:
This topic describes only the last steps in adding a CTI link to the system.
Additional LAN-related procedures are described in the PassageWay
Telephony Services Network Manager's Guide.
Task List: Removing a CTI Link
Obtain Form 2a, System Numbering: Extension Jacks.
Record the new values on Form 2a.
If necessary, read "Auxiliary Equipment" in System Programming ,
Chapter 3, for additional information.
Open the System Programming menu from the console or a PC with SPM.
Follow the procedure outlined in
Module" on page 6–89
link is located.
Program the change(s), following the appropriate instructions for "Auxiliary
Equipment" in System Programming , Chapter 3, or the appropriate
summary programming instructions below.
Follow the procedure outlined in
Module" on page 6–89
was located.
6
Type ext. no.
6
6
"Busying-Out and Restoring the MLX
to terminate service on the module where the CTI
"Busying-Out and Restoring the MLX
to restore service on the module where the CTI link
Issue 1
August 1998
Page 6-91
Dial ext. no.