Station Busy Screen - Lucent Technologies MERLIN LEGEND Release 6.1 System Manager's Manual

MERLIN LEGEND Communications System Release 6.1
System Manager's Guide 555-661-118
6 Managing the System
Introduction to System Programming
Idle States
You can begin some programming procedures only when all or part of the system
is not in use; this is called an idle state . The idle state must remain in effect until
you finish programming.
NOTE:
If a procedure requires an idle state, do it outside normal business hours.
If a procedure requires an idle state and an extension on the system is busy when
you begin, you see a screen like the one shown in
appropriate programming screen when the system is no longer busy.
Figure 6–6.
Table 6–4
and the procedures that can be performed only during that idle state.
NOTES:
1. The table includes all the procedures that fall into each idle-state
2. When an extension is in programming mode, the system considers it
OOOO TTQQ

Station Busy Screen

explains the various idle states, including a description of each state
category. Procedures that should be performed only by a Lucent
Technologies technician are noted.
busy. Thus, to perform a backup, make sure that no telephone is in
programming mode.
6
Figure 6–6. It changes to the
= a previously entered extension
= the slot and port number of the
busy extension
Issue 1
August 1998
Page 6-11