Changing Calling Group Assignments - Lucent Technologies MERLIN LEGEND Release 6.1 System Manager's Manual

MERLIN LEGEND Communications System Release 6.1
System Manager's Guide 555-661-118
6 Managing the System

Changing Calling Group Assignments

For a voice messaging system and auto attendant:
Console Procedure
PC Procedure
For the other auxiliary equipment noted above:
Console Procedure
PC Procedure
Changing Calling Group Assignments
Use this procedure to assign or remove an extension from a calling group.
Planning Guidelines
An extension can belong to only one calling group. A QCC cannot be a member of
a calling group. A delay announcement device should not be programmed as a
calling group member.
A calling group can be a Night Service group member.
NOTE:
In Release 6.1 and later systems, a calling group on one MERLIN
LEGEND system can provide coverage for extensions to another MERLIN
LEGEND system. For this coverage, the systems must be directly
connected by tie or PRI tandem trunks, and all systems must be in
Hybrid/PBX mode. See the Network Reference for details.
A maximum of 32 calling groups can be programmed. A calling group can include
a maximum of 20 extensions, but not all 32 calling groups can have this maximum
number because this would exceed the total extension capacity of the system.
If a linear hunting pattern is indicated on the back of the system planning form
(7d), be sure to assign extensions to the group in the exact order that they are
shown on the form. The system searches for an available member in the order in
which you assign the extensions to the group.
rings
+ Type no. of ms
+ Type no. of ms
Dial line/trunk no.
Type line/trunk no.
Drop
Drop Dial no. of ms
Drop Dial no. of ms
+ Type no. of rings
or or
6
6
Issue 1
August 1998
Page 6-67
Dial no. of