Lucent Technologies MERLIN LEGEND Release 6.1 System Manager's Manual page 256

MERLIN LEGEND Communications System Release 6.1
System Manager's Guide 555-661-118
6 Managing the System
Programming from a PC with SPM
To reach the System Programming menu, select
Perform the procedures contained in the task descriptions later in this chapter.
With a Local or Remote Modem Connection
The method you use to access SPM by modem depends on whether you are
programming onsite (locally) or from a remote location.
If you are onsite, the modem must be connected to a 012 or a 016 (T/R)
(Release 4.0 and later only) module on the control unit. To establish a
connection to the control unit's internal modem, dial
If you are at a remote location, do one of the following:
— Place a call to the system on a remote access line, enter the barrier
— Place a voice call to the system on a regular line and ask the operator to
Modem Connections
You must make a data connection to a modem. The following modem dialing
commands work for most modems. These may not be the commands your
modem uses; refer to the user guide that came with your modem for specific
information.
If the PC is in the same location as the control unit, type
If the PC is in a remote location and your system has activated the Remote
Access feature, type the following:
Then press
For example:
(4 to 11 digits) may be required between the
For example:
When the connection is made, the password prompt appears on the
screen. (You may have to press
password prompt.)
If you enter a telephone number of fewer than 11 digits, you must end it
with a pound sign (#).
code (if required), and dial the code for the internal modem (
transfer you to the modem (by dialing
answer tone, switch to data mode.
, the remote access telephone number, and
NOTE:
by pressing
6
.
) . When you hear the modem
.
. Also, a barrier code
and the
.
more than once to get the
Issue 1
August 1998
Page 6-21
.
) .
6
.
entries.