Table of Contents
Advertisement
MERLIN LEGEND Communications System Release 6.0
System Manager's Guide 555-660-118
6
Managing the System
Removing a CTI Link
extension, use the main extension number (for example, extension 12 in a
2-digit numbering plan), not the adjunct extension number (for example,
extension 712 in a 2-digit plan).
o
Follow the procedure in the preceding topic, "Busying-Out and Restoring
the MLX Module," to restore service on the module where the CTI link is
located.
o
When you have finished, file Form 2a with the rest of the planning forms.
o
To install the server-related hardware associated with the link, contact your
Lucent Technologies representative.
Programming Instructions
Console Procedure
PC Procedure
Removing a CTI Link
Use this procedure to remove the programming for a CTI (Computer Telephony
Integration) link from an MLX port on a 008 or 408 MLX module. This
hardware/software feature is available in Release 5.0 and later systems operating
in Hybrid/PBX mode.
NOTE:
This topic describes only the last steps in adding a CTI link to the system.
Additional LAN-related procedures are described in the PassageWay
Telephony Services Network Manager's Guide.
Task List: Removing a CTI Link
o
Obtain Form 2a, System Numbering: Extension Jacks.
o
Record the new values on Form 2a.
o
If necessary, read "Auxiliary Equipment" in System Programming , Chapter
4, for additional information.
o
Open the System Programming menu from the console or a PC with SPM.
o
Follow the procedure outlined in
Module" on page 6–91
link is located.
Å Ã
Type ext. no.
"Busying-Out and Restoring the MLX
to terminate service on the module where the CTI
6
Dial ext. no.
Ç Ç
6
6
Issue 1
February 1998
Page 6-93
Advertisement
Table of Contents
